CHAMPION PP3 - Manual (Page 21)

13
Troubleshooting
Troubleshooting
Condition Cause Solution
Sink pump will not run.
Low or no water.
Chemicals dispensers
will not work.
Main breaker OFF.
Control panel fuses blown.
Main water supply off.
Chemical supply low.
Dispenser defective.
Check breaker on panel.
Contact service agent.
Open supply valve.
Refill chemical container.
Contact Chemical Supplier.
Wash tank is sudsing
over.
Non-sudsing detergent is
required for operation.
Contact Chemical Supplier.
Water temperature low in
wash tank.
Water level sensor dirty.
Tank was filled with cold
water.
Clean water level sensor
in wash tank.
Drain and refill with hot
water (Min.115˚F/46˚C-
Max. 125˚F/52˚C.
Sink(s) will not drain. Drain screen(s) clogged.
Drain valve defective.
Building drain clogged.
Clean drain screen(s).
Contact Service Agent.
Contact Building
Maintenance.
Poor wash results. Wares incorrectly loaded.
in wash tank.
Clogged screens.
Water in sink needs
changing.
Chemical injectors not
feeding.
Tank heater defective.
Reposition wares or reduce
amount of wares.
Clean screens.
Drain and refill sink with
fresh water.
Contact Chemical Supplier.
Contact Service Agent.
Pumps run constantly. Sink may be operating in
the delay off mode.
Push Off button to stop.
The delay off mode will
restart from the beginning
and run an additional 4
hours when restarted.