CHAMPION PP3 - Manual (Page 15)

7
Operation
Follow the steps below to operate the machine in normal mode:
1. Turn the power on at the building main circuit breaker or service disconnect switch.
NOTE: The sink does not have a power on/off switch.
2. Close the drain on each tank by turning the drain handle clockwise to the nine o'clock
position. NOTE: The handle will lock in place when fully closed.
3. Fill the wash tank with hot water (minimum 115°F/46°C, maximum 125°F/52°C)
temperature to the water line mark.
4. Add detergent to the wash tank in accordance with the chemical supplier's instructions.
5. Fill the remaining tanks to the desired levels. These tanks do not have a water line mark.
6. Add sanitizer to the sanitizing sink in accordance with the chemical supplier's instructions.
continued on next page
Normal Operating Mode
Fill the wash tank up to the "Water Line" mark located on the
back wall of the compartment.
OPEN
CLOSED
DRAIN
To fully close the drains,
turn the drain handles clockwise
to the nine o-clock position
making sure it locks in place.