CHAMPION EUCCW Series - Manual (Page 44)

36
Installation Instructions _______

Optional Blower Dryer Assemby
Electric or Steam
Section Assemby
REFER TO THE BLOWER-
DRYER SERVICE MANUAL
P/N 114316
SHIPPED WITH THE
BLOWER-DRYER
ASSEMBLY
FOR COMPLETE
INSTALLATION
INSTRUCTIONS.
1. The blower dryer comes in electric or steam.
2. It ships on a separate pallet.
The vent cowl and mounting hardware are
included in the
accessories box and hardware
kit.
3. Lift the blower dryer off the pallet
with a forklift and place on the
end of the unload section.
If a forklift is not available, then
four (4) men are needed to lift
and install the unit manually.
4. Bolt the blower dryer in place using the
5/16-18 X 3/4" bolts, flat washers, and lock
washers from the hardware kit.
5. Fasten the vent cowl on the discharge end
of the blower dryer using the 1/4-20 plain
nuts, flat washers, and lock washers from the
hardware kit.
6. Connect the flex-tite conduit
to the junction box located at
the rear of the dishwasher.
7. Match wire numbers in the junction box and
connect with wire nuts.
8. Close the junction box.
9. Install the cowl to the end of the
blower dryer.