Brother FAX 580MC - Manual (Page 94)

14 - 2 S E T T I N G U P T H E M F C 6 6 0 M C A N D C O M P U T E R T O W O R K T O G E T H E R
Connecting the MFC 660MC to Your PC
Follow the instructions below to hook up the Multi-Function Link
®
Cable:
1
Position your Brother MFC near your personal computer CPU (maximum distance of
approximately 5–6 feet).
2
Make sure to unplug the machine’s power cord from the electrical outlet before
connecting the Multi-Function Link
®
cable.
Also, make sure the computer is turned off and unplugged from the electrical power
before you connect the Multi-Function Link
®
cable.
3
Connect the RJ-8 connector of the Multi-Function Link
®
Cable to the back of your
Brother MFC in the jack labeled PC I/F.
4
Connect the 25-pin male RS-232 connector of the Multi-Function Link
®
Cable to your
PC in the available female serial communications port. Use the 9-pin adapter if your
PC requires it. (See your PC owner’s manual for the correct interface port for
connection.) NOTE: If your PC is an IBM Aptiva, an MWAVE card is using
COM1. You must connect the Multi-Function Link
®
Cable to another COM
serial port that is available.