Carlin 601GAS Inst Manual - Manual (Page 3)

Model 601GAS burner — Instruction manual
Carlin part number MN601GAS Rev. 04/24/09
– 3 –
Where appliance instructions differ from this manual, follow the appliance instructions.
PLEASE read this first . . .
Follow the guidelines below to avoid potential severe
personal injury, death or substantial property damage.
Installer/service technician . . .
• Read all instructions before proceeding. Perform all procedures,
and in the order given to avoid potential of severe personal injury,
death or substantial property damage.
• Before leaving the site after start-up or service, review the User’s
information manual with the user. Make the user aware of all
potential hazards and perform the training outlined below.
Train the user . . .
• To properly operate the burner/appliance per this manual and the
appliance instructions and the User’s information manual.
• To keep this manual at or near the burner/appliance for ready ac-
cess by the user and service technician.
• To contact the service technician, gas supplier or fire department
should the user smell gas.
• To keep the appliance space free of flammable liquids or vapors
and other combustible materials.
• Do not use laundry products, paints, varnishes or other chemicals
in the room occupied by the burner/appliance.
• To contact the service technician at least annually for start-up and
burner/appliance service.
When servicing the burner . . .
• Disconnect electrical supply to burner before attempting to
service to avoid electrical shock or possible injury from moving
parts.
• Burner and appliance components can be extremely hot. Allow
all parts to cool before attempting to handle or service to avoid
potential of severe burns.
Codes and standards
Burner listings
Carlin 601GAS burners are UL listed for US, per UL795, for use with natural
gas or propane gas. The burner is equipped to meet CSD-1.
The installer/servicer is solely responsible for compliance
with all applicable codes and standards.
Burners for installation in Massachusetts require a nonrecycle
primary control. Make sure the burner is properly equipped
for Massachusetts installations.
United States installations
Burner/appliance installations in the United States must comply with the
latest editions of:
• “Installation of Domestic Gas Conversion Burners,” ANSI Z21.8.
• National Fuel Gas Code, ANSI Z223.1/NFPA 54.
• National Electrical Code, ANSI/NFPA 70.
• All additional applicable national, state and local codes.
Special attention flags
Please pay particular attention to the following when you see them through-
out this manual.
Notifies you of hazards that WILL cause severe personal
injury, death or substantial property damage.
Notifies you of hazards that CAN cause severe personal injury,
death or substantial property damage.
Notifies you of hazards that WILL or CAN cause minor per-
sonal injury or property damage.
Notifies you of special instructions on installation, operation or
maintenance that are important, but are not normally related
to injury or property damage hazards.
General information
Burner applications
Follow all instructions in this manual and the appliance manual. Where ap-
pliance instructions differ from this manual, follow the appliance instructions.
Read the label attached to the burner air tube to verify the burner is correct
for the appliance being used. See page 8 for procedures.
Damage or shortage claims
The consignee of the shipment must file damage or shortage claims im-
mediately against the transportation company.
When calling or writing about the burner . . .
Please provide us with the UL serial number and burner model number to
assist us in locating information. Enter this information on the Installation
Certificate in this manual. The certificate information can be helpful when
troubleshooting or obtaining replacement parts.
Fill out burner adjustment label
Fill out the burner adjustment label, located on the housing above the rating
label after completing installation and burner setup.
Should overheating occur: (1) shut off the manual gas control
to the appliance, (2) do not shut off the control switch to the
pump or blower.