BAND-IT Ultra Lok Free End - Manual (Page 2)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P07888 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 2
Ultra-Lok
Free End
Clamping
Instructions
Inspect buckle on completed clamp and tap down buckle shroud.
Band and Buckle Totes:
FRONT VIEW
Completed Free-End Clamp
(Visually inspect lock)
Buckle Shroud
Lock sheared in center
and formed inside
shroud
Important: Visually inspect lock formed in band as shown. If lock has slipped under the sheared surface of the
buckle, remove clamp and install a new one at reduced tension by lowering the drill clutch torque setting.
Shear Surface
Section View
Good Clamp
Bad Clamp
Lock has slipped back
under sheared buckle
surface
Warning:
For safety purposes,
retract band until end is
between tote side walls.
If band end is not accessible,
rotate roll band diameter
through handle until end
snaps into opening.
Line up 4 tabs on
outside of buckle box
with 4 slots in tote.
Press into tote.