BAND-IT M50389 Multi Lok Tool - Manual (Page 4)

Tools Required:
Hex Keys: 1/16", 7/64"
Parts May Be Required:
Blade: K83987
Cap Screw: M54587
Set Screw: A02887
Special Instructions:
It is critical the knife and blade be assembled with a zero-gap to ensure
clean cut-off. Once correctly positioned, use threadlocking compound
to prevent parts from shifting during use (allow sufficient time for
compound to cure).
Figure 1
Figure 4
Figure 2 Figure 3
The knife is now in the downward position - Figure 4. 5.
Installation Procedure:
Set the tool tension to -0-. 1.
Back-out cap screw (M54587) and set screw 2.
(A02887) - Figure 1.
Reposition/replace blade, but do not fully tighten 3.
screws yet.
Squeeze the handle completely and firmly strike the 4.
pull up lever against a non-metal surface to actuate
the knife - Figure 2 (note: you may also press firmly on
the pull up lever to actuate the knife - Figure 3).
M50389
Multi-Lok Tool
www. BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # M50350 rev. F
Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
Page 4 of 5
Blade Installation
Procedure