BAND-IT K50289 Ball-Lok/Self-Lok Tool - Manual (Page 4)

Installation Procedure:
Set the tool tension to -0-. 1.
Back-out set screw (M54587) and cap screw 2.
(A02887) - Figure 1.
Reposition/replace blade, but do not fully tighten 3.
screws yet.
Squeeze the handle completely and firmly strike the 4.
tension lever against a non-metal surface to actuate
the knife - Figure 2 (note: you may also press firmly on
the tension lever to actuate the knife - Figure 3).
Tools Required:
Hex Keys: 1/16", 7/64"
Parts May Be Required:
Blade: K93987
Cap Screw: M54587
Set Screw: A02887
Special Instructions:
It is critical the knife and blade be assembled with a zero-gap to ensure
clean cut-off. Once correctly positioned, use threadlocking compound
to prevent parts from shifting during use (allow sufficient time for
compound to cure).
Figure 1
Figure 4
Figure 2 Figure 3
The knife is now in the downward position - Figure 4. 5.
K50289
Ball-Lok / Self-Lok Tool
www. BAND-IT-IDEX.com BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
Document # K50250 rev. D
Copyright
BAND-IT-IDEX, Inc. 2009
All rights reserved
Page 4 of 5
Blade Installation
Procedure
Set Screw Cap Screw Set Screw Cap Screw