BAND-IT J00169 JR. Tool Adapter - Manual (Page 2)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P06287 rev. F
© Copyright
BAND-IT-IDEX, Inc. 2012
All rights reserved
www.BAND-IT-IDEX.com
Page 2 of 2
J00169 JR.
Tool Adapter
Repair Parts &
Assembly
J001 JR. ADAPTER REPAIR PARTS LIST
BAND-IT
PART #
ITEM # DESCRIPTION
J01499
1 HANDLE
2 CAM
J02299
3 BODY
4
PIVOT CAM PIN
J93099* 5
SCREW, SPECIAL
CUTTER BLADE
BACKING PLATE
HEX KEY, SPECIAL
J00587 6
SHEAR HOOK
(Design may vary)
J00987 7 PIN, PIVOT HOOK
J01387 8
HEX KEY, 3/16”,
SPECIAL LENGTH
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
*NOTE: Replacement cutter
blade kit design may vary.
Replace all parts as a kit.
ITEM 5: J93099 CUTTER BLADE KIT
CUTTER BLADE
SCREWS
BACKING
PLATE
Operating Tip: Keep the bolts tight (8-14 ft-lbs.). A loose bolt may cause cracking or premature wear of the
cutter blade and/or backing plate. This could result in improper clamp tensioning, locking, and cutting.
Operating Tip: Keep the leading edges of the cutter blade and backing plate free of metal shavings. Metal
shavings will result in clamp tail gouging during tensioning. Clean and hone the leading edges by hand.
Do not use power tools. Honing should polish surfaces, not remove material.
2
4
1
7
6
3
8 - Remove screw
with hex key