BAND-IT C00369 Heavy Duty Tool - Manual (Page 4)

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-0307 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P91687 Rev. H
© Copyright
BAND-IT-IDEX, Inc. 2010
All rights reserved
www.BAND-IT-IDEX.com
Page 4 of 4
C00369 Heavy Duty
Hand Tool
Cleaning &
Warranty
Gripper Cleaning Instructions:
1. To remove Gripper, align
Gripper Pin hole with notch in
tool frame. Using a punch and
hammer, punch Pin out of
Slide Block. 2. Using a wire brush, clean all
foreign matter from teeth. 3. To replace Pin, Gripper
Spring must be seated in
Tension Screw hole. Align
Gripper hole with Slide Block
hole and insert Pin using a
hammer.
Refer to website for warranty information: http://www.band-it-idex.com/warranty.html
NOTE: Periodically apply food-grade white lubricant or equivalent to Tension Screw thread (item
10 on page 3) to prevent excessive wear.
If tool fails to securely grip tail of clamp, follow Gripper cleaning instructions above.