BAND-IT A95079 Band-Lok - Manual (Page 3)

A95051.doc Rev “F“ Page 3 of 3
Operating Instructions
A95079 Band-Lok Tool
Warning:
Always wear safety glasses when operating
hand tool.
Instructions:
1. Turn tension adjustment knob until desired
tension setting is displayed in tension
indicator window. Space between numbers
counts as one-half setting. See step 6.
2. Extend handle open to release gripping
mechanism and insert clamp tail into tool
through front load entry.
3. Squeeze handle repeatedly to tighten band
around object. Be sure to release handle
completely to use full pull-up stroke of tool.
Buckle must be secure against the tool
head. Once the preset tension has been
reached, the handle will no longer release
completely.
4. To cut-off excess clamp tail, squeeze handle
one last time. Once the band is cut, the
handle must be released to separate the tool
from the clamp.
5. The tool must be reset by extending the
handle out until it snaps into place. The tool
will be ready to apply the next clamp.
6. Tension Setting Range:
.312 Band-Lok 0 - 8
Tension Indicator
Window
Handle
Tension
Adjustment
Knob
Wrap tie around object.
Insert tail end of tie
through slot at opposite
end.
Clamp Tail