B&W Trailer Hitches 1100R - Manual (Page 4)

Retract the latch pin by pulling the handle out until it stops and then rotating it. Place the 2-5/16” ball
(8) in the hitch receiver. Engage the latch pin by rotating the handle. Be certain the latch pin passes
through the holes in the 2-5/16” ball and fully engages through the hitch receiver. Repeat this process
with the 2-5/16” ball in all eight positions. Grease the square base of the 2-5/16” ball.
STEP TEN
Copyright 2014
B&W Custom Truck Beds, Inc.
ALL RIGHTS RESERVED 1100R - 05 01 2014
LATCH
PIN
TAB
IN−LINE
DRIVER SIDE
STEP NINE– INSTALL LATCH PIN RELEASE HANDLE
WARNING: LATCH PIN WILL NOT FUNCTION PROPERLY IF HANDLE IS NOT INSTALLED CORRECTLY.
Install the latch pin release handle by inserting it through the slot in
the end of the center section on the driver’s side of the truck. Align the
handle eyelet with the square hole in the latch pin so the handle is in
line with the latch pin as shown. Secure the handle to the pin with the
5/16 X 3/4” carriage bolt and 5/16” locking flange nut as shown. Note:
The included 5/16” cap screw can replace the carriage bolt if wrench
access on the “cab side” of the handle is limited. Tighten the nut until
it is secure. Do not over-tighten and deform the handle eyelet.