APG DCR-1006 user manual - Manual (Page 16)

DCR-1005 and DCR-1006 Rev. A4, 10/08
16
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
Outputs
The DCR-1005 and DCR-1006 contain 4 SPDT relays which are capable of
handling a 10 amp load. These relays have programmable BEGIN and END
points as well as TYPE of operation. The LED’s on the DCR indicate the status
of the relays. The programming units must be the same as those displayed. i.e.
If gallons are displayed the trip location should be set in gallons.
MODE DESCRIPTION PARAMETERS EXPLANATION
12 Begin Trip 1 Units = mode 1 Sets the begin point
Default = 2.5 ft. of Trip 1.
13 End Trip 1 Units = mode 1/mode 3 Sets the end point
Default = 2.9 ft. of Trip 1.
14 Trip 1 Type Range = 0 - 7 Selects the type of function
Default = 0 Trip 1 will perform.
See Trip Type Explanation for details.
15 Begin Trip 2 Units = mode 1/mode 3 Sets the begin point
Default = 3 ft. of Trip 2.
16 End Trip 2 Units = mode 1/mode 3 Sets the end point of
Default = 3.4 ft. of Trip 2.
17 Trip 2 Type Range = 0 - 7 Selects the type of function
Default = 0 Trip 2 will perform.
See Trip Type Explanation for details.
18 Begin Trip 3 Units = mode 1/mode 3 Sets the begin point
Default = 3.50 ft. of Trip 3.
19 End Trip 3 Units = mode 1/mode 3 Sets the end point
Default = 3.90 ft. of Trip 3.
20 Trip 3 Type Range = 0 - 7 Selects the type of function
Default = 0 Trip 3 will perform.
See Trip Type Explanation for details.
21 Begin Trip 4 Units = mode 1/mode 3 Sets the begin point
Default = 4.0 ft. of Trip 4.
22 End Trip 4 Units = mode 1/mode 3 Sets the end point of
Default = 4.40 ft. of Trip 4.
23 Trip 4 Type Range = 0 - 7 Selects the type of function
Default = 0 Trip 4 will perform.
See Trip Type Explanation for details.