Allen&Heath Scepter USER GUIDE - Manual (Page 37)

Audio Owner Manual Section 5
USER CONFIGURED OPTIONS
There are a number of User options available on the Scepter mixer. They are
implemented with removable jumper links that the user can move to different
combinations of header pins; no soldering is necessary. (except for the left and right
Stereo Return options).
To alter any of the User Configured Options you will have to gain access to
the internal circuit cards. Please read the ACCESS TO MIXER CIRCUITS
procedure in the SERVICE ACCESS section.
OPTION DESCRIPTIONS
Input Channel Options
Seven different options are available on each Input channel:
Direct Out
Aux send source select
Pre-EQ source select
Pre-EQ mute select
1 of 3 choices
1 of 3 choices for each Aux
1 of 3 choices
1 of 2 choices
Direct Out
Three choices are available for the Channel Direct Out. Normally the Direct
Out is set to follow the Fader and Mute switch, however there may be situations
when you may want the Direct Out to stay active even if the Channel is muted. This
would allow you to use each input as an independent preamp. If the channel is
muted, the signal would appear only at the Direct Out jack; the Aux sends and
pan feed would be cut.
1 Post-Fader/Post-Mute The Direct Out follows the Channel fader and Mute
switch. This option is factory set.
2 The Direct Out follows the Channel fader but the
Mute switch has no effect on the signal.
3 Pre-Fader/Pre-Mute Neither the fader nor Mute switch affect the Direct
out.
32