Allen&Heath Scepter USER GUIDE - Manual (Page 11)

Audio Owner Manual Section 1
ELECTRONIC PERFORMANCE
0.776 Volts RMS 1
OVU 1.23 Volts RMS
Unreferenced represents Voltage Gain
MAX VOLTAGE GAIN:
Figures include input and group fader boost
MIC IN to Out
LINE IN to Out . . . . . . . . ..*..........*....*
to Mono Out . . .
FX RETURN to L/R Out . . . . . . . . . . . . . . . . . . . .
INPUT PAD
-16dB
INPUT GAIN CONTROL
. . . ..*...*..............* 70dB with Pad
FREQUENCY RESPONSE:
Equalizer set to flat response or switched out . . . . . . . . . . . . . . to 20kHz
INTERNAL OPERATING . . . ..*......**............* Channel= L/R= -2dBu
ALL OUTPUTS AND INSERTS IN-PHASE REF TO XLR PIN 2 INPUT
AND TIP CONNECTOR.
OUTPUTS: LEFT RIGHT MONO
Self Compensating Electronically Balanced
Capable of Balanced or Unbalanced operation
Max level Bal, Unbal
Recommended load 600 ohms or greater
Connectors 3 pin XLR Type
Pin 1 Gnd (with lift switch)
Pin 2 = +
Pin 3
When pin 2 or 3 grounded, Opposite output pin gain is increased by 6dB
ALL OTHER MONO OUTPUTS
Unbalanced; Max level
Recommended load 600 or more:
2k or more for Channel Insert Direct Out
Connector
Phone Jack
Tip is Ring and Sleeve= ground
DISTORTION:
6