AirLive WL-5470AP - Manual (Page 35)

AirLive WL_5470AP User’s Manual
30
4.6 Universal Repeater Mode Setting
Alias Name You can set the alias name for this device. limited not exceed 32 characters.
Disable Wireless
LAN Interface
Check the box to disable the Wireless LAN Interface, by so doing, you won’t be
able to make wireless connection with this Access Point in the network you are
located. In other words, this device will not be visible by any wireless station.
Band You can choose one mode of the following you need.
~ 2.4GHz (B): 802.11b supported rate only.
~ 2.4GHz (G): 802.11g supported rate only.
~ 2.4GHz (B+G): 802.11b supported rate and 802.11g supported rate. The default
is 2.4GHz (B+G) mode.
SSID The SSID differentiates one WLAN from another; therefore, all access points and
all devices attempting to connect to a specific WLAN must use the same SSID. It is
case-sensitive and must not exceed 32 characters. A device will not be permitted
to join the BSS unless it can provide the unique SSID. An SSID is also referred to
as a network name because essentially it is a name that identifies a wireless
network
Channel Number The number of channels supported depends on the region of this Access Point. All
stations communicating with the Access Point must use the same channel.
SSID of extended
Interface
When in Universal Repeater mode, you have to enter the ESSID of other’s
AP/Router that device want to connect.
The device SSID and the SSID of extended interface can be the same or different.
When you are using the universal repeater mode, please make sure the remote