AirLive WL-5470AP User Manual

Page 28

AirLive WL_5470AP User’s Manual

When Enable Wireless Access Control is checked, only those clients whose wireless MAC addresses

listed in the access control list can access this Access Point. If the list contains no entries with this function

being enabled, then no clients will be able to access this Access Point.

Wireless Access Control

Mode

Select the Access Control Mode from the pull-down menu.

Disable: Select to disable Wireless Access Control Mode.

Allow Listed: Only the stations shown in the table can associate with the AP.

Deny Listed: Stations shown in the table won’t be able to associate with the AP.

MAC Address

Enter the MAC Address of a station that is allowed to access this Access Point.

Comment

You may enter up to 20 characters as a remark to the previous MAC Address.

Apply Changes

Press to save the new settings on the screen.

Reset

Press to discard the data you have entered since last time you press Apply

Change.

Delete Selected

To delete clients from access to this Access Point, you may firstly check the

Select checkbox next to the MAC address and Comments, and press Delete

Selected.

Delete All

To delete all the clients from access to this Access Point, just press Delete All

without selecting the checkbox.

Reset

If you have made any selection, press Reset will clear all the select mark.