AirLive WL-5470AP - Manual (Page 16)

AirLive WL_5470AP User’s Manual
11
3.8 WISP + Universal Repeater Mode
In this mode, the AP behaves virtually the same as the WISP mode, except one thing: the AP can also send
wireless signal to the LAN side. That means the AP can connect with the remote WISP AP and the indoor
wireless card, and then provide IP sharing capability all at the same time! However, the output power is
divided between 2 wireless sides and proper antenna installation can influence the performance greatly.
To set the operation mode to “WISP + Universal Repeater”, Please go to “Mode JWISP + Universal
Repeater” and click the Setup button for configuration.
3.9 GW Mode
In this mode, the AP behaves virtually the same as the WISP mode, except one thing: the AP can also send
wireless signal to the LAN side. That means the AP can connect with the remote WISP AP and the indoor
wireless card and then provide IP sharing capability all at the same time! However, the output power is
divided between 2 wireless sides, and proper antenna installation can significantly improve the performance.