AirLive SNMP-24MGB - Manual (Page 177)

4. Web Management in SNMP-24MGB
AirLive SNMP-24MGB v2 User’s Manual 170
Function name:
Events Configuration
Function description:
The Trap Events Configuration function is used to enable the switch to send out the
trap information while pre-defined trap events occurred. The switch offers 24 different
trap events to users for switch management. The trap information can be sent out in
two ways, including email and trap. The message will be sent while users tick (;) the
trap event individually on the web page shown as below.
Parameter description:
Trap:
Cold Start, Warm Start, Link Down, Link Up, Authentication Failure, User
login, User logout
STP: STP Topology Changed, STP Disabled, STP Enabled
LACP: LACP Disabled, LACP Enabled, LACP Member Added, LACP Port Failure
GVRP:
GVRP Disabled, GVRP Enabled
VLAN:
VLAN Disabled, Port-based VLAN Enabled, Tag-based VLAN Enabled,
Metro-mode Vlan Enabled, Double-tag Vlan Enabled
Module Swap:
Module Inserted, Module Removed, Dual Media Swapped
4.17.1 Event
Function name:
Email Configuration
Function description:
Alarm configuration is used to configure the persons who should receive the alarm
message via either email. It depends on your settings. An email address has to be set
in the web page of alarm configuration. Then, user can read the trap information from
the email. This function provides 6 email addresses at most. The 24 different trap
events will be sent out to SNMP Manager when trap event occurs. After ticking trap
events, you can fill in your desired email addresses. Then, please click <Apply> button
to complete the alarm configuration. It will take effect in a few seconds.