AirLive POE-FSH1008AT - Manual (Page 7)

1. Introduction
AirLive POE-FSH1008AT User’s Manual
2
* Note:
 This switch does not work with passive PoE devices. It uses 802.3at/af PoE standard
 Please make sure your device's PoE port can accept 48V active PoE power.
1.2 Guide to the Chapters
 Chapter 1: Introduction and Quick Setup guide. All the essential information including
IP Address and Password information are in the Quick Setup section.
 Chapter 2: Detail installation instruction including how to make Cat. 5 Cable
 Chapter 3: LED indicators
 Chapter 4: Detail information on Web management including how to setup remote
management.
1.3 Quick Setup
This section provides the essential information for experienced users to operate the switch
immediately. For detailed installation instruction, please see chapter 2 for more information.
Power-On the switch
 The POE-FSH1008AT has a built-in power supply to operate with 100 ~ 240V AC, 50 ~
60Hz power source.
 The AC power cord connector is located at the rear of the unit and the On/Off switch is
next to the connector.
 After the Switch is powered on, it will perform “self-diagnostic” test. This process takes
about 5 seconds to complete.
LED Table
Note : G1 is Port 9 and G2 is Port 10
LED Color/Status Description
Power Amber On Power on
Link/ ACT
(Port 1-8)
Green On Link Up
Green Blinking Data activating
PoE
Amber On Port is linked to Power Device
Off No Power Device is connected
Link/ ACT
(G1-G2)
Green On Link Up
Green Blinking Data activating