2N VoiceBlue MAX v1.1 User Manual
Page 80
80
AT%N#0=op/np,…op/np
List of prefixes replaced by new prefixes
(#–number of netlist; op–old prefix;np–new
prefix)
AT%N#1=pr/n,…pr/n
List of prefixes dialled into ISDN (to be used for
LCR table) pr=prefix n=length of number
(parameter /n is optional)
AT%N#2..7=pr/n,…pr/n
Other 7 lists of prefixes dialled into ISDN
AT%N#9=net,max
Net–network number, max–default length of
number dialled from ISDN
LCR Table
AT&R
Shows LCR table
AT%R##=net,hh:mm/hh:mm/w
,gr*
Settings of line ## (0..63) of LCR tablenet –
number of network list (0..8)hh:mm/hh:mm/w*
– line using time limitation gr – GSM group
numbers
Test Calls
AT!SGxx=dial
Initiates testing call from AUX interface (xx is
the called interface):
00..31 GSM module
32– to GSM via GSM module according to call
prefix
AT!WGxx
Connects the following call from interface xx to
AUX interface
00..31 from GSM No.
32 first incoming calls from GSM
AT!D
Terminates call on AUX interface
Trace
Trace can be activated for only one
session at a time
AT!RE
Start tracing of error messages on active
interface
AT!Lx
Start tracing of LAN & Telnet on layer xx=2 –
Layers IP,TCP,Telnetx=3 – Layers TCP,
Telnetx=4 – Layer Telnet
AT!Rx
Start tracing of ISDN PRI & GSM on layer xx=1 –
Layers 1,2,3,4x=2 – Layers 2,3,4x=3 – Layers
3,4x=4 – Layer 4
AT!RR
Start tracing (AT!R2) to COM1 interface
AT!RX
Stop tracing (AT!R2) to COM1 interface
SMS Control
SMS control can be activated for only
one session at a time
AT!G=#
A6 – activate control via used session55 –
deactivate control via used session99 –
deactivate control on all sessions
AT^MS=ch
Module status ch=0 – 31