2N VoiceBlue MAX v1.1 - Manual (Page 78)

78
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Configuration commands
Status Information
AT&V Overview of all system settings
AT&VI Overview of ISDN PRI settings
AT&V0 Overview of basic GSM settings
AT&V# Overview of GSM group # settings (#=1–8)
AT&VALL Overview of all GSM group settings
AT&N#
Overview of parameters of network list #
(#=1–8)
AT&NALL Overview of parameters of all network lists
AT&R Overview of LCR lines
Default Reset
AT&FRES Reset with gateway factory settings
System Settings
AT%S70=x.x.x.x IP address
AT%S71=x.x.x.x IP address mask
AT%S81=
Initialisation string for setting of mode connected
to the gateway COM2
AT%S90=x
Type of assignment of B–channels to GSM
modules (0–rotating; 1–locked; 2–according to
credit)
AT%S91=x,y
Way of call information recording (0– no record;
1– successfully connected outgoing call; 2–
successfully connected incoming calls; 3–
successfully connected incoming and outgoing
calls; 5– all outgoing calls; 6– all incoming calls;
7–all incoming+outgoing calls)
Y = to each call add NET info (1) or no (0)
AT%S93=x
Global selection of SIM card (0= according to
GSM group, 1–8= number of SIM holder)
AT%S98=xxxx PIN code for SIM cards inserted in the gateway
AT%S99=
dd.mm.yy.w/hh:mm:ss
Gateway date and time settings
AT%X00=hout,hin,min
Automatic logout of GSM moduleshout ...hour
when the modules start to log out randomlyhin
...hour when the modules start to log in
randomlymin ...minimum number of modules in
a group (2..15) that always remain logged–in
AT%X80=name/pass
Username/password for access via IP port (this
parameter is write only– you cannot see its
value)