2N VoiceBlue Next v3.0 - Manual (Page 72)

AT Interface 4.2
72
00..31 from GSM No.
32 first incoming calls from GSM
AT!D Terminates call on AUX interface
Trace Trace can be activated for only one session at a time
AT!RE Start tracing of error messages on active interface
AT!Lx Start tracing of LAN & Telnet on layer x
x=2 – Layers IP,TCP,Telnet
x=3 – Layers TCP, Telnet
x=4 – Layer Telnet
AT!Rx Start tracing of ISDN PRI & GSM on layer x
x=1 – Layers 1,2,3,4
x=2 – Layers 2,3,4
x=3 – Layers 3,4
x=4 – Layer 4
AT!RR Start tracing (AT!R2) to COM1 interface
AT!RX Stop tracing (AT!R2) to COM1 interface
SMS Control SMS control can be activated for only one session at a time
AT!G=# A6 – activate control via used session
55 – deactivate control via used session
99 – deactivate control on all sessions
AT^MS=ch Module status ch=0 – 31
*module: ch,sim,sts3,sts2,phs2,type Response to AT^MS:
ch – number of wireless engine
sim – number of currently used SIM: 0-none, 1-8-holder 1-8
sts3 – status of layer 3
sts2 – status of layer 2
phs2 – substatus of layer 2
type – type of wireless engine
AT^MI=ch Module info ch = 0 -31
*minfo: ch,sim,netid,”oper”,new,cnt Response to AT^MI
netid – network ID of active wireless network
oper – name of active wireless network
new – number of received and saved SMS on SIM card
cnt – total number of sent SMS messages according to statistics
*smsinc: ch,ix,sts,mem SMS message has been received and saved
ix – index number of saved SMS (0-250)
sts – status of SMS (from +CMGL: ix.sts.len)
mem – type of used storage (1,2,3)
*smsrep: ch,ix,sts,mem SMS status confirmation has been received
sts – reserved (0)
*smsout: ch[/id],ref,req SMS message was sent and not saved to SIM card
Ref – reference number of SMS (0-255) – to be used in status
confirmation messages
ID – third party identification number of SMS
*smspdu: ch,ix,sts,len,pdu,csum Content of SMS message
len – length of SMS message (number of bytes in PDU)
PDU – content of message in PDU format
csum – checksum of all PDU bytes (2 hexa digits) calculated
without carry
*smsdel: ch,ix SMS message deletion confirmation
*smserr: ch[/id],ix,req,err,cms Fault command response, or SMS not sent
req – required wireless engine or GSM group
err – error code (6-busy,40-write,41-read,42-delete,43-list)
cms – error cause from wireless engine
*smssel: ch,cnt SMS storage change confirmation
AT^SX=ch SMS listing - request for listing of all SMS messages and status