Web configuration interface 3.4 – 2N VoiceBlue Next v3.0 User Manual
Page 51
Web Configuration Interface
3.4
51
Mobility Extension (DTMF settings)
Start dialling (quick call forwarding) - DTMF code for quick forwarding start.
End dialling (quick call forwarding) - DTMF code for quick forwarding end.
Hold call - DTMF code for active call holding.
Hang up call - DTMF code for call termination.
Follow me activation - activation of the Follow me function. The GSM
gateway starts routing call to the defined GSM/UMTS subscriber number. The
default value is *55.
Follow me deactivation - deactivation of the Follow me function. The default
value is #55.
SMS at no answer activation - activation of the SMS at no answer function
for a registered user. The default value is *33.
SMS at no answer deactivation - deactivation of the SMS at no answer
function for a registered user. The default value is #33.
Tip
The SMS at no answer and Follow me functions can be
enabled/disabled using the above mentioned DTMF codes by calling the
GSM gateway from a registered mobile user phone. The values of these
functions can be changed using the configuration interface too (see
below).
Others
PIN - PIN code for the SIM cards that request the PIN code.
Caution
A SIM card with a PIN code other than that set in the GSM gateway
configuration will be blocked with the „pin-err‟ cause. To unblock the so-
rejected SIM card, enter the correct PIN on your mobile phone!
End of dialling (empty=off) - a selectable DTMF code for DTMF dialling end in
the event of a DISA incoming call. The default value is „#‟.
VoIP parameters
VoIP functions
Day of deleting statistics on VoIP (every month) - the day of automatic
deletion of call statistics on the VoIP interface. None = no deletion.
SIP protocol settings
Use CLIP from INVITE field - the CLIP as set in the Contact or From field will
be used for routing calls into GSM/UMTS networks.
Send 180 ringing instead of 183 session progress.
Send 200 OK instead of 180/183.
Send 200 OK and BYE when rejected from GSM.