2N VoiceBlue Next v3.0 - Manual (Page 70)

AT Interface 4.2
70
AT&CR Call file listing and deleting (PRIGW awaits pressing of the # key to
delete this line /with call info/ from memory and sends next line)
Configuration commands
Status Information
AT&V Overview of all system settings
AT&VI
Overview of ISDN PRI settings
AT&V0
Overview of basic GSM settings
AT&V#
Overview of GSM group # settings (#=1-8)
AT&VALL
Overview of all GSM group settings
AT&N# Overview of parameters of network list # (#=1-8)
AT&NALL Overview of parameters of all network lists
AT&R Overview of LCR lines
Default Reset
AT&FRES Reset with gateway factory settings
System Settings
AT%S70=x.x.x.x IP address
AT%S71=x.x.x.x IP address mask
AT%S81= Initialisation string for setting of mode connected to the
gateway COM2
AT%S90=x Type of assignment of B-channels to GSM modules (0-rotating;
1-locked; 2-according to credit)
AT%S91=x,y Way of call information recording (0- no record; 1- successfully
connected outgoing call; 2- successfully connected incoming
calls; 3- successfully connected incoming and outgoing calls; 5-
all outgoing calls; 6- all incoming calls; 7-all incoming+outgoing
calls)
Y = to each call add NET info (1) or no (0)
AT%S93=x Global selection of SIM card (0= according to GSM group, 1-8=
number of SIM holder)
AT%S98=xxxx PIN code for SIM cards inserted in the gateway
AT%S99= dd.mm.yy.w/hh:mm:ss Gateway date and time settings
AT%X00=hout,hin,min Automatic logout of GSM modules
hout ...hour when the modules start to log out randomly
hin ...hour when the modules start to log in randomly
min ...minimum number of modules in a group (2..15) that
always remain logged-in
AT%X80=name/pass Username/password for access via IP port (this parameter is
write only- you cannot see its value)
System Control
AT&BSYS=RESET Reset of PRIGW
AT&Gxx=RESET Reset of GSM module xx
AT&Gxx=BLOCK Block of GSM module xx
AT&Gxx=DOWN Transfer of GSM module into the sleep mode
AT&Gxx=ON Transfer of GSM module into the idle mode
Basic GSM Settings
AT%G00=rr,gggggg,gggggg,
gggggg,gggggg,gggggg
g,r=Number of GSM group for each GSM module
AT%G01=mode,atms,atfs Voice processing settings (for GM22 GSM modules only)