2N StarGate/BlueTower v5.2 - Manual (Page 77)

77
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Port Modes
This item helps you set each of your gateway ports. The settings are based on the LCR
table including relevant routing/rejecting rules for all incoming and outgoing calls.
GSM Basic Parameters
Digits Dialled from VoIP
Minimum numbers from VoIP – set the minimum count of digits to be dialled
into the GSM network.
Maximum numbers from VoIP – set the maximum count of digits to be dialled
into the GSM network.
Wait for next digit [s] – set the timeout for 2N StarGate / BlueTower
®
gateway to wait for the next digit dialled from VoIP to GSM.
Calls
Relax timeout [s] – set the timeout between the end of the last call and
beginning of the next call made via one and the same GSM module (incoming
and outgoing calls are rejected during this timeout). The recommended relax
value is 2 seconds – please do not change this setting unless absolutely
necessary.
Holiday List
List of days on which calls will be routed like on weekends in the LCR.
DTMF Settings
Minimum delay between two identical DTMF characters [s/100] received.
Tone Detector Settings
The GSM gateway can automatically detect user defined tones transmitted by
GSM/UMTS for setting up outgoing calls to the GSM/UMTS networks. In general, they
are tones of a transferred number. For the purpose of such detection, the GSM
gateway automatically terminates the call and tries to set it up via another available
outgoing group (if defined in the LCR).
Frequency 1;2;3;4 – define the frequencies for the tone to be detected.
Sequence list – set the sequence of the tones to be detected.
Voice Parameters of GSM Modules
Set the voice level in the gateway GSM modules.
Audio Level DSP
Set the voice level for calls in the gateway signal processor.