2N StarGate/BlueTower v5.2 User Manual
Page 131
131
List of Networks
AT%N#0=op/np,…op/np
List of prefixes replaced by new prefixes
(#-number of netlist; op-old prefix;np-new
prefix)
AT%N#1=pr/n,…pr/n
List of prefixes dialled into ISDN (to be used for
LCR table) pr=prefix n=length of number
(parameter /n is optional)
AT%N#2..7=pr/n,…pr/n
Other 7 lists of prefixes dialled into ISDN
AT%N#9=net,max
Net-network number, max-default length of
number dialled from ISDN
LCR Table
AT&R
Shows LCR table
AT%R##=net,hh:mm/hh:mm/w
,gr*
Settings of line ## (0..63) of LCR tablenet –
number of network list
(0..8)hh:mm/hh:mm/w* – line using time
limitation gr – GSM group numbers
Test Calls
AT!SPxx=dial
Initiates testing call from AUX interface (xx is the called interface):
1..15, 17-31 B-channel
32-rotating B-channel
AT!SGxx=dial
Initiates testing call from AUX interface (xx is the called interface):
00..31 GSM module
32- to GSM via GSM module according to call prefix
AT!WPxx
Connects the following call from interface xx to AUX interface
1..15, 17-31 from B-channel No.
32 first incoming calls from ISDN
AT!WGxx
Connects the following call from interface xx to AUX interface
00..31 from GSM No.
32 first incoming calls from GSM
AT!D
Terminates call on AUX interface
Trace
Trace can be activated for only one session at a time.
AT!RE
Start tracing of error messages on active interface
AT!Lx
Start tracing of LAN & Telnet on layer xx=2 – Layers
IP,TCP,Telnetx=3 – Layers TCP, Telnetx=4 – Layer Telnet
AT!Rx
Start tracing of ISDN PRI & GSM on layer xx=1 – Layers 1,2,3,4x=2
– Layers 2,3,4x=3 – Layers 3,4x=4 – Layer 4
AT!RR
Start tracing (AT!R2) to COM1 interface
AT!RX
Stop tracing (AT!R2) to COM1 interface