2N StarGate/BlueTower v5.2 - Manual (Page 127)

127
2N TELEKOMUNIKACE a.s., www.2n.cz
®
4.2 Configuration Commands
Status Information
AT&V Overview of all system settings
AT&VI Overview of ISDN PRI settings
AT&V0 Overview of basic GSM settings
AT&V# Overview of GSM group # settings (#=1-8)
AT&VALL Overview of all GSM group settings
AT&N# Overview of parameters of network list # (#=1-8)
AT&NALL Overview of parameters of all network lists
AT&R Overview of LCR lines
Default Reset
AT&FRES Reset with gateway factory settings
System Settings
AT%S70=x.x.x.x IP address
AT%S71=x.x.x.x IP address mask
AT%S81=
Initialisation string for setting of mode connected to the
gateway COM2
AT%S90=x
Type of assignment of B-channels to GSM modules
(0-rotating; 1-locked; 2-according to credit)
AT%S91=x,y
Way of call information recording (0- no record; 1-
successfully connected outgoing call; 2- successfully
connected incoming calls; 3- successfully connected
incoming and outgoing calls; 5- all outgoing calls; 6- all
incoming calls; 7-all incoming+outgoing calls)
Y = to each call add NET info (1) or no (0)
AT%S93=x
Global selection of SIM card (0= according to GSM group,
1-8= number of SIM holder)
AT%S98=xxxx PIN code for SIM cards inserted in the gateway
AT%S99=
dd.mm.yy.w/
hh:mm:ss
Gateway date and time settings
AT%X00=hout,hin,min
Automatic logout of GSM moduleshout ...hour when the
modules start to log out randomlyhin ...hour when the
modules start to log in randomlymin ...minimum number
of modules in a group (2..15) that always remain
logged-in
AT%X80=name/pass
Username/password for access via IP port (this parameter
is write only- you cannot see its value)