2N SmartGate - User Manual - Manual (Page 36)

31
Password for Follow-me activation / disabling
If you program SmartGate as DialThru gateway and fill in Follow-me number,
function Follow-me is active. If you fill in password for Follow-me
activation/disabling, you can activate/disable function Follow-me without PC
programming.
Off-Hook FXS line and dial PASSWORD plus to disable the function.
Off-Hook FXS line and dial PASSWORD plus to activate the function again.
Setting options: 0-8 characters (0-9)
Default setting: blank
Prefix
Dialed number prefix identifying the call type. "Other numbers" line is used for
calls with prefixes that are not included in the table.
Setting options: 0-16 characters (0-9,*,#)
Default setting: blank
Call enable
This parameter allows/bars calls with corresponding prefixes.
Setting options: YES/NO
Default setting: YES
Number length
The parameter defines the expected length of dialed number. It enables to start
dialing into GSM or FXO interface immediately after the last digit is dialed. If the
telephone number to be dialed is shorter, a timeout is respected. The "0" setting
means that the function is disabled.
Setting options: 0, 3-15
Setting step: 1
Default setting: 0
End with #
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES/NO
Default setting: NO
Remove
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step:
1
Default setting: 0