2N SmartGate - User Manual User Manual

Page 35

FXO routing table

Calls from FXO interface are routed according to “FXO calls rote to” parameter. You

can set SmartGate as DialThru gateway or as gateway for extension line of PBX.

You can program Follow-me function for the DialThru gateway.
For gateway for extension line of PBX you can fill in the FXO routing table.

According to the prefix of dialed number on FXO interface you can:

· Bar the number to be dialed – SmartGate hangs up, the call isn’t established;

· Accelerate connection establishing by knowing the number length for the given

prefix;

· Accelerate connection establishing by allowing to terminate dialing with a #;

· Modify the number to be dialed by removing and/or adding prefix.

The principle of table function is the same as in the FXS routing table. The call is

controlled according to parameters on the row with dialed number prefix match.
Remember to fill in the "Other prefixes" line for a number whose prefix is not found in
the table.

FXO calls route to

The main parameter for FXO calls routing. You can program SmartGate as
DialThru gateway, or as gateway for extension line of PBX.

DialThru gateway:

Incoming ringing is immediately connected to FXS interface. If function Follow-
me is set, SmartGate starts to establish GSM call to Follow-me number after
defined number of rings. Routing table FXO is disabled.
gateway for extension line of PBX:
SmartGate detects incoming ringing and Off-Hook the line after programmed
number of rings, if it is possible to make call to GSM. SmartGate generate dial
tone and after dialing takes an action according to FXO routing table.
Setting options:

FXS

- DialThru gateway

GSM

- gateway for extension line of PBX

Default setting: FXS - DialThru gateway

Follow-me number

If you program SmartGate as DialThru gateway, fill in telephone number for
Follow-me function. SmartGate starts to establish GSM call to Follow-me number
after defined number of rings. Then you can receive incoming FXO call on
telephone line or in GSM network. Blank parameter disables Follow-me function.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank

Number of rings to Follow-me

If you program SmartGate as DialThru gateway and Follow-me number is filled
in, SmartGate starts to establish GSM call to Follow-me number after defined
number of rings. Then you can receive incoming FXO call on telephone line or in
GSM network.
Setting options: 0-255
Step:

Default setting: 1