2N SmartGate - User Manual - Manual (Page 30)

25
Type of transmitted dialing
Set type of dialing for automatic dial-in from GSM and for dialing during outgoing
call from FXS interface.
Setting options:
DTMF -SmartGate transmits tone dialing
- -for future use
Default setting: DTMF
Minimal On-Hook [ms]
Parameter defines minimal time of line On-Hook between calls. Set the
parameter longer then duration of FLASH on your PBX.
Setting options: 100-25500 ms
Step: 100 ms
Default setting: 1500 ms
Maximal Off-Hook without dialing [s]
Parameter defines maximal time of line Off-Hook before dialing to FXO interface
during outgoing call from FXS interface. Set up shorter time then timeout from
extension line Off-Hook and dialing receiver disconnection on your PBX. In this
case PBX usually changes dial tone to busy tone. If defined timeout passes
before dialing, SmartGate shortly hangs up, after that Off-hooks again and then
dials.
Setting options: 1-255 s
Step: 1 s
Default setting: 15 s
Beep after dialing end
If SmartGate is programmed as FXO gateway, parameter enables a beep to
signal the end of dialing (beginning of outgoing call establishing).
Setting options: YES/NO
Default setting: YES
Dial tone – frequency [Hz]
Setting of frequency/frequencies of dial tone.
Setting options: 1-3400 Hz
Setting step:
1 Hz
Default setting: 425 Hz
Dial tone - cadence
This tone is generated after Off-Hook in case SmartGate is ready to accept
dialing.
Setting options:
Continuous -SmartGate generate continuous dial tone
Morse A -SmartGate generate dial tone with 330/330/660/660 ms
cadence
Default setting: Continuous