Superflex inputs and outputs, Superflex inputs and outputs -45 – JLG 600SC_660SJC ANSI Service Manual User Manual
Page 85
SECTION 4 - BOOM & PLATFORM
3120794
– JLG Lift –
4-45
Superflex Inputs And Outputs
18 Pin Connector (Green)
Optimizer Plug
Superflex LED’s
• The Superflex has 3 LED’s the top is input, the center is
power, and the bottom is out put.
• Footpedal pressed and joystick trigger engaged, you
will light up the center LED on the Superflex, also their
will be 12 volts at #11 & #12 on the 18 pin plug, once
you release the pedal the 12VDC will disappear.
• Once the joystick is moved in any position, the 3 LED’s
will chase each other letting you know the Superflex
has received the input and that it is sending it out to the
drive pumps EDC.
Amperage & Ohm Values (Approximate Values)
Inputs
#1
(Red Wire)
Digisensor (Steer)
#2
(Not Used)
#3
(Red Wire)
Digisensor (Drive)
#4
(Not Used)
#5
(Red)
Tach Input-Speed
#6
(Not Used)
#7
(Yel/Red)
Horsepower Input
#8
(Not Used)
#9
(Red)
Hi- Speed Input for Drive
Digisensor
#10
Specified Output
12 Volt Power
#11
(Yel/Red)
Positive
#12
(Black)
Negative
Outputs
#13
(Red)
Left Track Fwd
#14
(Red)
Left Track Rev.
#15
(Red)
Right Track Fwd.
#16
(Red)
Right Track Rev.
#17
(Red)
Auxiliary (Dump Valve)
A (Wht/Blk)
58-2
B
(Org/Red)
49-21
C (Org/Red)
49-22
D
(Wht/Red)
57-2
(Engine Bell Housing)
EDC
:
Resistance: 16. 0 ohms
Steer: (Left)
Wire Org. 7/3
60 – 63 ma
Steer: (Right)
Wire Org. 8/3
60 – 63 ma
Drive: (Fwd)
Wire Org. 7/3
100 – 103 ma
Drive: (Rev)
Wire Org. 8/3
100 – 103 ma
(Pump Side) EDC:
Resistance: 16. 0 ohms
Steer: (Left)
Wire Org. 7/4
60 – 63 ma
Steer: (Right)
Wire Org. 8/4
60 – 63 ma
Drive: (Fwd)
Wire Org. 8/4
100 - 103 ma
Drive: (Rev)
Wire Org. 7/4
100 – 103 ma