Belkin PM01110 User Manual

Page 68

G Wireless Router

sections

table of contents

UsInG THe Web-based adVanCed UseR InTeRfaCe

entering settings into the Virtual server
To enter settings, enter the IP address in the space provided for the

internal (server) machine, and the port(s) required to pass� Then select

the port type (TCP or UDP), check the “Enable” box, and click “Apply

Changes”� Each inbound port entry has two fields with five characters

maximum per field that allows a start and end port range, e�g� [xxxxx]-

[xxxxx]� For each entry, you can enter a single port value by filling in

the two fields with the same value (e�g� [7500]-[7500]) or a wide range

of ports (e�g� [7500]-[9000])� If you need multiple single port values or a

combination of ranges and a single value, you must use multiple entries

up to the maximum of 20 entries (e�g� 1� [7500]-[7500], 2� [8023]-[8023],

3� [9000]-[9000])� You can only pass one port per internal IP address�

Opening ports in your firewall can pose a security risk� You can enable

and disable settings very quickly� It is recommended that you disable

the settings when you are not using a specific application�

setting Client IP filters
The Router can be configured to restrict access to the Internet, email, or

other network services at specific days and times� Restriction can be set

for a single computer, a range of computers, or multiple computers�