beautypg.com

Belkin PM01110 User Manual

Page 12

background image

10

G Wireless Router

sections

table of contents

1

2

4

5

6

7

8

9

10

3

KnoWInG yoUR RoUTeR

7� Power Jack
Connect the included 5V DC power supply to this jack�

8� Connections to Computers (Wired Computer Ports) – Gray
Connect your wired (non-wireless) computers to these ports� These

ports are RJ45, 10/100 auto-negotiation, auto-uplinking ports for

standard UTP category 5 or 6 Ethernet cable� The ports are labeled 1

through 4� These ports correspond to the numbered LEDs on the front

of the Router�

9� Connection to Modem (Modem Port) – yellow
This port is for connection to your cable or DSL modem� Use the cable

that was provided with the modem to connect the modem to this port�

Use of a cable other than the cable supplied with the cable modem may

not work properly�

10� Reset button
The “Reset” button is used in rare cases when the Router may function

improperly� Resetting the Router will restore the Router’s normal

operation while maintaining the programmed settings� You can also

restore the factory default settings by using the “Reset” button� Use

the restore option in instances where you may have forgotten your

custom password�

a� Resetting the Router
Push and release the “Reset” button� The lights on the Router will

momentarily flash� The “Power” light will begin to blink� When the

“Power” light becomes solid again, the reset is complete�

b� Restoring the factory defaults
Press and hold the “Reset” button for at least 10 seconds, then release

it� The lights on the Router will momentarily flash� The “Power” light will

begin to blink� When the “Power” light becomes solid again, the restore

is complete�