Belkin PM01110 - Manual (Page 46)

44
G Wireless Router
sections
table of contents 1 2 3 4 5 7 8 9 10 6
UsInG THe Web-based adVanCed UseR InTeRfaCe
1� IP address
The “IP address” is the internal IP address of the Router� The default
IP address is “192�168�2�1”� To access the Web-Based Advanced User
Interface, type this IP address into the address bar of your browser�
This address can be changed if needed� To change the IP address,
type in the new IP address and click “Apply Changes”� The IP address
you choose should be a non-routable IP� Examples of a non-routable IP
are: 192�168�x�x (where x is anywhere between 0 and 255), and 10�x�x�x
(where x is anything between 0 and 255)�
2� subnet Mask
There is no need to change the subnet mask� This is a unique, advanced
feature of your Belkin Router� It is possible to change the subnet mask
if necessary; however, do NOT make changes to the subnet mask
unless you have a specific reason to do so� The default setting is
“255�255�255�0”�
3� dHCP server
The DHCP server function makes setting up a network very easy by
assigning IP addresses to each computer on the network automatically�
The default setting is “On”� The DHCP server can be turned OFF if
necessary; however, in order to do so you must manually set a static
IP address for each computer on your network� To turn off the DHCP
server, select “Off” and click “Apply Changes”�
4� IP Pool
The range of IP addresses set aside for dynamic assignment to the
computers on your network� The default is 2–100 (99 computers)� If you
want to change this number, you can do so by entering a new starting
and ending IP address and clicking on “Apply Changes”� The DHCP
server can assign 100 IP addresses automatically� This means that
you cannot specify an IP address pool larger than 100 computers� For
example, starting at 50 means you have to end at 150 or lower so as not
to exceed the 100-client limit� The starting IP address must be lower in
number than the ending IP address�