Snorkel TL49K-sn8500+ - Manual (Page 28)

24 508159-000 TL49K
5. Cage Overload
In the event of the cage being overloaded, an audible alarm will sound and
the cage controls will cut out.
To re-start, enough load must be removed from the cage so that the
alarm stops sounding.
In cases where the overload can not be immediatley removed or the cage
has fouled, then the overload override selector switch can be used to move
the platform to a safe position so that the overload can safely removed.
The Key, Motor Run/Deadman and a Control Lever must be
operated at the same time to effect this action
4. Emergency Procedure, Manual Raising of Outriggers.
In the event of power failure, the outriggers can be raised to their transport
position.
First the hand pump hose fitted to port HP1, must be redirected from HP1,
to port HP2, and the blanking plug from HP2 must be replaced into HP1,
using a 22mm spanner.
Once
connected, move an Outrigger Control Lever in the required
direction of movement, and operate the hand pump. When the Outrigger
starts to raise, continue depressing the control lever.
Some hydraulic oil will be lost during this procedure. This will
still allow Emergency operations, but will need to be replaced
before full normal use can resumed.
!
EMERGENCY CONTROLS