Snorkel MB26-sn435-999 User Manual

Page 18

2. Operation & Specifications

2-9

Figure 4: Lower Control Panel

TYPICAL OPERATION

Raising the mast.

• The Keyswitch located on the Upper Control box must be turned on.

• Select Mast by pressing the Mast button (3)

• Press and hold the enable button (1),

• Activate the Rocker Switch (2) in the direction required.

ELEVATING & LOWERING THE WORK PLATFORM

Before operating the MB20N Work Platform it is imperative that the pre-operation Safety

Inspection has been completed and any deficiencies have been corrected. The operator

must also be fully trained in the use of this machine.

Before beginning any operation, the following checks should be carried out.

W A R N I N G

ENSURE that no other persons are within 1 metre of the machine.

Be aware of the pothole protection bar hazard on both sides of the

machine.
LOOK up and around for obstructions before performing the lift or drive

functions.
DO NOT overload the platform.
DO NOT operate near electrical power cables, keep within national

safety limits.
THIS WORK PLATFORM IS NOT ELECTRICALLY INSULATED

NOTE: Chassis controls are for service use only.

1. Enable button

2. Rocker switch

3. Mast selection button

4. Jib selection button

5. Rotate selection button

6. Emergency Stop