Caution – Snorkel AB46JE User Manual

Page 36

Chapter 8 – Prestart Inspection

AB46JE – 0260072

Figure 8.15 – Power-Input Connector

2. Plug an electrical tool into the receptacle at the

platform and try to operate the tool to verify proper

operation of the outlet.

The outlet is equipped with a ground fault circuit inter-

rupter (GFCI). Use the following procedure to test the

GFCI.

1. Push the test button (refer to Figure 8.16).

Figure 8.16 – Electrical Power Outlet

2. Plug an electrical tool into the outlet and verify the

power is off.

If the power was off, push the reset button to

restore power.

If the power was on, repair or replace the re-

ceptacle.

All Motion Alarm

The machine may be equipped with an optional all mo-

tion alarm.

Operate the machine functions to ensure that the

alarm sounds to warn personnel in the area that the

aerial platform is in motion.

•

Power-Input Connector

Test Button

Reset Button

Test Button

Reset Button

Placards and Decals

To inspect the placards and decals:

1. Inspect all safety and operational placards and de-

cals. Make certain they are in place, in good condi-

tion, and are legible.

2. Clean the placards and decals with soap and water,

and a soft cloth if the words or pictures cannot be

seen.

Caution

Solvents may contain hazardous ingredients. Follow
the manufacturer’s label for proper use and disposal.
Wear protective gloves and splash-proof safety
glasses when using solvents.

3. Remove wet paint overspray with a natural biode-

gradable solvent and a soft cloth.

4. Replace any missing or illegible placards or decals

before operating the aerial platform.

Placard and decal kits are available from Snorkel.

The safety related placards and decals are illustrated on

the following pages.