Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 6)

Figure 6-3
• Install the u-bolt over the axle tube and through the track bar relocation bracket, use a
flat washer and nylock nut to secure the u-bolt.
• Once all the hardware is installed in the track bar relocation bracket you can begin to
torque all the hardware. Torque the 9/16 bolt to 150 ft-lbs, the ½” bolts to 90 Ft-lbs, and
the 3/8” bolts and u-bolt to 40 ft-lbs. Wait until the Jeep is sitting at right height to attach
the track bar.
7. INSTALL STEERING STABILIZER
• The track bar relocation bracket also allows you to relocate the steering stabilizer to the
top of the tie rod.
• Loosen the u-bolts on the tie rod steering stabilizer bracket and rotate it to the top of the
tie rod as shown in Figure 7-1. Tighten the u-bolts when finished. Attach the large end of
the steering stabilizer to the tie rod bracket.
• Attach the shaft end of the steering stabilizer to the track bar relocation bracket using
the factory nut and bolt and a ½ washer between the bushing and the track bar relocation
bracket. See Figure 7-2
• Tighten both steering stabilizer mounting bolts to 60 ft-lbs.