Synergy 5222-04 - Jeep JK 2 Door Weld-In Harness Bar - Manual

SYNERGY MFG. 870 INDUSTRIAL WAY, SAN LUIS OBISPO, CA (805) 242-0397
PPM-5224 JK 4 DOOR REAR CAGE KIT
Version 1.2
GENERAL NOTES:
• These instructions are also available on our website; www.synergymfg.com.
Check the website before you begin for any updated instructions and additional
photos for your reference.
• This is a weld in harness bar, all welding should be performed by an experienced
welder with proper welding equipment
• This kit works with either a soft top or hard top
• Use extreme care when welding and grinding in the interior of your Jeep, remove
or cover any components you do not want welding spatter or grinding sparks to
damage.
INSTRUCTIONS:
1. Remove the hard top or soft top. If using a soft top, remove the door surrounds and
the entire soft.
2. Remove the roll bar padding, upper seat belt bolt and upper B-pillar trim from both
sides. Use a trim stick or similar trim removal tool to remove the plastic trim piece.
#2 in the picture below needs to be removed. There are 2 push
pins in location #1 that secure it to the roll bar.
3. Test fit the 5222-04 harness bar as shown below. It should use the soft top hinge
brackets as a guide for proper location.