Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 2)

PPM-8056 - Rear Track Bar Bracket
PPM-8001 - High Steer Drag Link Kit
PPM-8066 - Front Brake Line Kit
PPM-8066 - Rear Brake Line Kit
PPM-8074 - Rear Lower Shock Mounts (Pair)
2. Read all the following steps before beginning installation. If you do not have the
proper tools or ability to install the components properly do not attempt installation.
Find a creditable, local shop to do the installation work.
FRONT SUSPENSION
3. REMOVE STOCK PARTS
• Disconnect the front track bar at the axle bracket. It is easiest to do this when the
suspension is at the ride height position. If you are replacing the track bar with an
adjustable one you can completely remove the front track bar.
• Remove the automatic transmission skid plate if equipped to prevent damage to the
front drive shaft when the suspension is drooped out.
• Use a floor jack under the center of front axle to lift the tires off the ground.
Place jack stands under each frame rail just behind the lower control arm mounts to
support the weight of the Jeep. Raise or lower the floor jack under the front axle to
remove and install suspension components. The jack should stay under the axle the
entire time the front suspension is being installed.
• Now remove these suspension components and retain the hardware in this order
• Front Wheel/Tires
• Sway bar links
• Steering stabilizer
• Shocks
• Drag link; remove the bent end from the steering knuckle and unthread the
draglink with the adjuster sleeve from the inner tie rod, you can leave the inner tie
rod attached to the pitman arm.
• Lower the axle and remove the springs, make sure the wheel speed sensors wires
are not overextended, loosen any retaining clips if needed to allow enough slack.