Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 5)

Figure 5-2
6. INSTALL TRACK BAR RELOCATION BRACKET
• Position the new track bar relocation bracket over the stock track bar bracket as shown
in Figure 6-1. Secure the bracket to the axle using the supplied 9/16 x 3” bolt and spacer,
the spacer goes where the track bar was located in the stock bracket. There are 3
cylindrical spacers included with this kit, use the shorter one for this step. Use a washer
under the head of the bolt and under the top lock nut.
Do not tighten this nut at this time; wait until all the other hardware is installed.
See Figure 6-2.
Figure 6-1 Figure 6-2
• Install the (2) 3/8 x 1” bolts in the track bar relocation bracket on either side of the
9/16” bolt, use a flat washer under the bolt head and under the nut, then secure
with a top lock nut.
• Install one of the 1.5” spacers between the stock sway bar tab and the side of the track
bar relocation bracket in the lower hole with a ½ x 3” bolt and top-lock nut; use a washer
under the bolt head and nut. See Figure 6-3