Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 10)

9. INSTALL BUMPSTOP SPACERS AND COIL SPRINGS
• Locate and center punch the center of the bump stops strike pad on the axle coil spring
mounts. Drill a 3/8” hole.
Figure 9-1
• Put the bump stop bolt though the bump stop and slide the bump stop into the bottom of
the coil spring.
• Install the coil spring while holding the bump stop inside the coil. When the coil is in
place, align the bump stop bolt with the hole that was drilled. Install the bump stop bolt
through the hole and the 3/8” serrated nut onto the bump stop bolt.
Hand tighten the nut and then use a 5/16” allen wrench through the coil spring to tighten
the bump stop bolt.
10. INSTALL SHOCKS
• Install the shocks using the stock lower mounting nut/bolt. Use the new stem bushings,
washers and nuts.
• Tighten the lower bolts to 56 ft-lbs
• Install the thicker of the two upper stem bushing nuts and tighten until the bushing
begins to bulge out. Install and tighten the jam nut.