Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 14)

• Now remove these suspension components and retain the hardware in this order
• Rear Wheel/Tires
• Sway bar links
• Shocks
• Lower the axle and remove the springs, make sure the wheel speed sensors wires
are not overextended, loosen any retaining clips if needed to allow enough slack
14. INSTALL BRAKE LINES
• Remove the stock brake lines from the frame hard line connection and brake caliper,
install the new brake lines with the new banjo washers. Install the frame bracket as
shown.
Figure 14-1
• The same brake line is used at all 4 corners, once the brake line is installed at the caliper
you can slightly bend the 90 bent tube end of the brake line at the caliper toward the
frame similar to the stock brake line.