Synergy 8022-X - Jeep JK Synergy Stage 2 Suspension System - Manual (Page 17)

17. INSTALL REAR TRACK BAR RELOCATION BRACKET
• Cut part of the factory track bar off as shown in the following pictures. The pictures are
shown using a 4 ½” grinder with a cut off wheel, but a sawz-all can also be used.
• Attach the new track bar relocation bracket to the factory bracket as shown with the
new 9/16” bolt and lock nut; use a flat washer under the bolt head and lock nut.
• Install the u-bolts over the axle tube and through the track bar relocation bracket, use a
flat washer and nylock nut to secure the u-bolt.
• Torque the 9/16 bolt to 150 ft-lbs, and the 3/8” u-bolts to 40 ft-lbs
• Wait until the vehicle is sitting at ride height to attach the track bar.