Synergy 8023-X - Jeep JK Synergy Stage 3 Suspension System - Manual (Page 9)

• Install the thicker of the two upper stem bushing nuts and tighten until the bushing
begins to bulge out. Install and tighten the jam nut.
12. INSTALL SWAY BAR LINKS
• Install the driver side anti-way bar relocation bracket using a 1.5”spacer and ½” x
3” bolt and top-lock nut; use a washer under the bolt-head and nut.
Figure 12-1
• Run a 1/2” drill bit or reamer through each side of the stock sway bar holes to
enlarge the holes for the new rod end studs.
Figure 12-2
• Make sure the sway bar end links are the same length by adjusting the rod ends.
• Install the sway bar link rod ends to the sway bar as shown in Figure 12-1, tighten
to 60 ft-lbs.
• Install the driver side sway bar link to the sway bar relocation bracket using the
stock nut/bolt as shown in Figure 12-1. Torque the lower sway bar nut/bolts to 75
ft-lbs.