Synergy 8023-X - Jeep JK Synergy Stage 3 Suspension System - Manual (Page 3)

Figure 4-1
• The same brake line is used at all 4 corners, once the brake line is installed at the
caliper you can slightly bend the 90 bent tube end of the brake line at the caliper
toward the frame similar to the stock brake line.
Figure 4-2
• Wait until the rear brake lines are installed to bleed the brakes.
5. INSTALL LOWER CONTROL ARMS
• Remove the stock control arms and save the mounting hardware
• Trim the top of the axle bracket as shown for clearance for the new arms.