Synergy 8023-X - Jeep JK Synergy Stage 3 Suspension System - Manual (Page 11)

15. INSTALL BRAKE LINES
• Remove the stock brake lines from the frame hard line connection and brake
caliper, install the new brake lines with the new banjo washers. Install the frame
bracket as shown.
Figure 15-1
• The same brake line is used at all 4 corners, once the brake line is installed at the
caliper you can slightly bend the 90 bent tube end of the brake line at the caliper
toward the frame similar to the stock brake line.
Figure 15-2
• You can now bleed the brake system.
16. INSTALL LOWER CONTROL ARMS
• Remove the stock control arms and save the mounting hardware
• We recommend that you preset the length of the lower control arms. For 3-4.5”
of lift, we recommend a length of 20.25” measured from the center to center of
the bushings. This length works well when using the stock length upper control
arms and for longer upper control arms when using a CV style rear drive line. If