Synergy 8023-X - Jeep JK Synergy Stage 3 Suspension System - Manual (Page 13)

Figure 17-1
• Tighten and torque both upper control arm bolts to 125 ft-lbs and the pinch bolt to
50 ft-lbs when final adjustment is done.
18. INSTALL BUMPSTOP SPACERS
• Install the new rear bump stop spacers. The bump stop spacers should be oriented
so they angle forward. See Figure 18-1. Use a washer under the head of the 3/8
bolts and use the serrated nut on the bottom. Tighten to 30 ft-lbs
Figure 18-1
19. INSTALL REAR TRACK BAR RELOCATION BRACKET
• Cut part of the factory track bar off as shown in the following pictures. The
pictures are shown using a 4 ½” grinder with a cut off wheel, but a sawzall can
also be used.