Lukas Compact Units - Manual (Page 20)

20
CAUTION!
Since LUKAS hydraulic units are designed for top performance, only those
components in the spare parts lists of the relevant unit may be replaced.
Further components in the unit may only be replaced if:
- You have participated in appropriate LUKAS service training,
- You have the explicit permission of the LUKAS customer service (on request,
check for granting permission. Check is necessary in each individual case.)
REMARK:
Do not carry out any repairs without the relevant LUKAS spare parts list, since
this contains the necessary torques for screws and / or important additional
information.
CAUTION!
Attention must be paid to ensuring that no fuel can escape from units with
combustion engines during repair work.
Repairs 11.
11.1 General
Servicing may only be carried out by the manufacturer or personnel trained by the
manufacturer and by authorised LUKAS dealers.
Only LUKAS spare parts may be used to replace all components (see spare parts list) since
special tools, assembly instructions, safety aspects, inspections might have to complied with
(see also chapter "Maintenance and service”).
During all installation work, pay particular attention to the cleanliness of all components
as contaminants could cause damage to the hydraulic unit.
WARNING / DANGER / CAUTION!
Protective clothing must be worn when repairs are being carried out, since
parts of the units can also be pressurised in an idle state.
REMARK:
Before you use couplings from a different company, you must contact LUKAS or
an authorised dealer.
Function test
• No suspicious noises
• Checks at nominal pressure (75% of maximum pressure)
(Recommendation: Carry out the load test with a fully assembled rerailing system. LUKAS
also offers a range of appropriate test equipment.)